Aastra 5380 - Setting the Operator Phone

Operator phone
Aastra 5380/Aastra 5380ip 123
eud-1282/1.3 – R3.0 – 04.2013
Setting the operator phone
You can configure up to 10 line keys on level 1 of an Aastra M535.
Adding and setting operator phone lines
You can make a number of settings that affect the telephone's response when some-
one calls on a Line key.
Note:
The settings are made once for all the Line keys.
Menu
Setting up the operator phone:
Press the Menu Foxkey.
Settings
Scroll to Settings and press the Select Foxkey.
Operator phone
Scroll to Operator phone and press the Select Foxkey.
Company A/Company B
Depending on the configuration select Company A or Company B.
➔The display shows the properties with which you can configure the Line key.
<Audio setting>
Select the required audio setting and confirm with the Ok Foxkey.
Setting possibilities for ringing:
• Off for no ringing tone, On for instant ringing tone, and ringing tone After
10s, After 20s and After 30s and confirm with the Ok Foxkey.
• Melody and Speed: You can listen to each setting using the Test Foxkey.
Setting possibilities for answering mode:
• Key to answer the call by pressing the line key, Handset to answer by picking
up the handset, and Hands-free to answer automatically with hands-free.
• Using Handset or Hands-free you must also specify the Priority with 1 being
the highest priority, and 8 the lowest. This setting is useful for the two-com-
pany systems.
• The Handset and Hands-free settings only work when the ringing signal is
activated.