Personalizing your phone
Aastra 612d 105
eud-1584/1.0 – R3.0 – 04.2013
Formulating functions
This section explains how to express and execute an individual function, for
example call forwarding, using function commands and function codes.
Function commands, function codes
You can use the predefined selection to allocate functions to a configurable key (see
chapter "Storing a function on a key - function key", page 102). You can also write your
own functions using function commands and function codes (select Free configurable
function). The function commands are listed here; the function codes can be found in
the User's Guide "User’s Guide Function Codes" on the Aastra DocFinder.
You can use function commands to define a function to suit your personal require-
ments. A function can consist of one or more function commands, function codes,
and the phone number.
The following function commands are available:
"I" Seize line
"H" Seize line in hands-free mode
"X" Disconnect
"P" Pause 1 second before the next operation
"N" Use the phone number entered in call preparation
"." Control key function (up-circuit system)
"Z" Activate/deactivate DTMF mode
"R" Use the phone number last dialled
"Y" Disconnect and reseize the line
Other formulation examples:
"IR" Seize line ("I"),
Dial phone number last dialled ("R")
"I201" Seize line ("I") and dial phone number 201
"I*21201X" Seize line ("I"),
activate call forwarding unconditional ("*21") to phone number 201,
disconnect ("X")
Formulating a function code and storing it under a key (example: “Activate presence status”):
www.InternetVoipPhone.co.uk | sales@internetvoipphone.co.uk | 0800 088 48 46
To Next Page
Loading...
Need help?
General
