TA7102i Hardware Installation
© 2014 Aastra Sweden | 153_1531 ANF 90114| A | 2014-01-24 A 17
• The TA7102i is accessible for future upgrade, maintenance and troubleshooting, and cables
can be easily connected.
• The cabling is away from the following:
• Sources of electrical noise such as radios, transmitters, and broadband amplifiers.
• Power lines and fluorescent lighting fixtures.
• Water or moisture that could enter the casing of the TA7102i.
• The airflow is not restricted around the TA7102i or through the vents of the unit. The unit
requires a minimum of 25 mm (1 in.) clearance.
• The operating temperature is between 0°C and 40°C.
• The humidity is not over 85% and is non-condensing.
Wiring Requirements
Make sure that the telephone wiring, LAN and WAN cables reach the device and can be
dressed in a manner that is safe for the wiring, does not pull or create lateral stress on the
connectors on the device, and does not present a trip hazard to personnel working in the vicinity
of the equipment. Do not connect any cable or wiring at this time.
To Next Page
Loading...