TA7102i Hardware Installation
© 2014 Aastra Sweden | 153_1531 ANF 90114| A | 2014-01-24 A 4
1 About this Manual
The TA7102i offers two Ethernet connectors switches enabling to establish two connections
between conventional analog telephones or Group 3 fax machines and either a WAN, a LAN or
a personal computer. It can be used to provide connectivity to broadband access equipment for
a Service Provider’s IP Telephony offering to residential or SME markets.
1.1 Document Objectives
The TA7102i Hardware Installation Guide provides technical information on how to physically
install the TA7102i. It also describes the cabling required for the TA7102i device.
The information included in this guide consists of:
• Hardware descriptions of the TA7102i device
• Hardware installation instructions
• Installation scenarios examples
• LED indications
• Cabling and pin-out data
Please refer to the Dgw v2.0 Software Configuration Guide for software configuration
information.
Use the TA7102i Hardware Installation Guide in conjunction with the appropriate publications
listed in “Related Documentation”
.
1.2 Intended Audience
This guide is intended for the following audiences:
• Technical staff who are familiar with electronic circuitry, networking theory and have
experience as an electronic technician.
• System administrators with a basic networking background and experience, but who might
not be familiar with the TA7102i device.
• System administrators who are responsible for installing and configuring networking
equipment and who are familiar with the TA7102i device.
1.3 Related Documentation
In addition to this manual, the TA7102i document set includes the following:
• Dgw v2.0 Software Configuration Guide.
•
To Next Page
Loading...