TA7102i Hardware Installation
© 2014 Aastra Sweden | 153_1531 ANF 90114| A | 2014-01-24 34
5 Appendix A – Standard Compliance and
Safety Information
This Appendix lists the various standards compliance of the TA7102i.
5.1 Disclaimers
The following are the disclaimers related to the TA7102i.
Federal Communications Commission (FCC) Part 15
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help
Note: Any changes or modifications not expressly approved Aastra could void the user’s
authority to operate the equipment.
CE Marking
DECLARATION OF CONFORMITY
Please see
www.aastra.com.
To Next Page
Loading...