If a more extreme repositioning is required, whether it be for reasons
of comfort or clearance in certain studio rig configurations, this can
be achieved with coupler extenders, spacers and intermediate arms
which utilize the star plate system for adjustment. Ask your agent
for a configuration that meets your needs.
4.3 TRIPOD USE
In order to use the XTRprod on a standard tripod, the tripod's
quick release plate must be fastened to the underside of the camera
body with its standard 3/8-16 screw. Make sure to use only a quick
release plate screw provided by the manufacturer; non-standard
screws longer than 8mm (1/3") can fracture the base casting and da-
mage the camera's electronics.
4.4 SHOULDER OPERATION
One of the most attractive features of the Aaton system has always
been its comfort and ease of use in handheld situations.
The XTR line does not require the use of shoulder braces or addi-
tional padding for handheld operation. The contour of the camera
and magazine is designed to fit snugly around the operator's shoul-
der. The wooden handgrip is attached to the front rod coupler at a
slight angle to bring the operator's elbow into his side and increase
stability.
The system can be completely built off the 15mm front rods wi-
thout the use of a bridgeplate to allow for quick changing from
shoulder to tripod operating modes.
4.5 CARRYING HANDLE
The carrying handle of the XTRprod is reinforced to safely accommodate
any carrying, operating or mounting situation.
75
THE AATON SYSTEM
To Next Page
Loading...
