4.5.1 3/8 Accessory Screw
The handle features a 3/8-16
insert to receive accessories
such as french flags and light-
weight monitors. Be sure not
to use a 3/8 screw longer than
10mm (7/16"); longer screws
can fracture the insert casting
and damage the viewfinder's
optics.
4.5.2 Mounting from the
Carrying Handle
The 3/8 insert, along with a guide hole at the rear of the handle, can
also be used to build a plate to undersling the camera or to configu-
re the rig for Steadicam low mode use. For this reason, the handle
features a long flat top surface that is parallel to the bottom of the
camera.
4.5.3 Tape Measure Stud
The handle is also equipped with a hideaway tape measure stud,
which is positioned between the rods directly behind the 3/8 insert.
To use this stud, pull it up and fasten the ring of a standard assis-
tant's tape measure around it; the stud holds the tape measure zero
point precisely at the film plane.
4.6 TRANSPORT
One often overlooked, yet vital factor in the proper functioning and lon-
gevity of your camera equipment is your transportation practices. A few
good shipping habits can avert potential damage caused by careless mes-
senger services and airport handling.
When shipping and carrying your equipment, it is always good
76
To Next Page
Loading...
