AAXA Technologies M7 - Powering ON the projector; Powering OFF the projector

Getting Started
1. Connect the power cord to the M7.
2. Connect the other end of the power cord into the wall power source.
3. Toggle the On / O󰀨 switch on the side of the projector to the “ON” position - the
projector should automatically turn on.
4. If the projector does not automatically turn on with the “Power Switch” toggled to the
“ON” position, press the “ON/OFF POWER” button on the remote to start the
projector.
4
Powering ON the projector
Chapter 2
Powering OFF the projector
Standby Mode
1. To transition to “STANDBY” mode, press the power button on the remote control.
2. The optical engine should power o󰀨 and the fan should stop spinning. A red LED
light is on indicating that the projector is in Standby Mode. The projector is now in
“STANDBY” mode and can be turned on using the remote control.
*Note: Standby mode will still consume a small amount of power.
1. To turn o󰀨 the projector, toggle the “Power Switch” to the “OFF” position. This will
fully turn o󰀨 the projector.