Press the button. You can delete all the channels and Transponder in the
selected satellite will be deleted.
4.2.3 Search Channels from Satellite
A: Satellite Search
1. Highlight the
Satellite
and press the OK button to enter satellite list. And
then
select one satellite you want to search.
2. Complete the antenna settings of this satellite.
3. Highlight the
Start Search
and select
satellite
then press the OK button
to
confirm.
B: Multi Satellites Search
1. Highlight the
Start Search
and select
Multi satellites
then press the OK
button.
2. Highlight the satellites in the satellite list, but make sure they are all
configured to
your DiSEqC Switch before press the OK to mark them.
3. Press Exit will start searching programs of the satellites you have marked.
C: Blind Search
1. Highlight the
Satellite
and press the OK button to enter satellite list. And
then
select one satellite you want to search.
2. Complete the antenna settings of this satellite.
3. Highlight the
Start Search
and select
Blind Search
then press the OK
button to confirm.
D: TP Search
1. Highlight the
Satellite
and press the OK button to enter satellite list. And
then
select one satellite you want to search.
2. Complete the antenna setting of this satellite.
3. Highlight the
Transponder
and press the OK button to enter
TP
list. And
then
select one transponder you want search.
4. Highlight the
Start Search
and select
Transponder
then press the OK
To Next Page
Loading...
