bdiGDB for BDI2000 (PowerPC 7440/7450/86xx) User Manual 19
© Copyright 1997-2015 by ABATRON AG Switzerland V 1.13
Breakpoints:
There are two breakpoint modes supported. One of them (SOFT) is implemented by replacing appli-
cation code with a TRAP instruction. The other (HARD) uses the built in breakpoint logic. If HARD is
used, only 1 breakpoint can be active at the same time.
The following example selects SOFT as the breakpoint mode:
BREAKMODE SOFT ;SOFT or HARD, HARD uses PPC hardware breakpoints
All the time the application is suspended (i.e. caused by a breakpoint) the target processor remains
freezed.
To Next Page
Loading...
