What to do if network processes do not function on Abatron BDI2000?
If network processes aren't functioning after a successful firmware load for your Abatron Computer Accessories, ensure the BDI2000 is properly connected to the network via LAN cable or media converter. Also, verify that the IP address entered in the BDI2000 configuration is correct.
What to do if Abatron Computer Accessories are not working with the target system?
If you're unable to work with the target system after successfully loading the firmware on your Abatron Computer Accessories, consider these potential causes: * Check the pin assignment (BDM/JTAG connector) of the target system. * Ensure correct target system initialization by entering an appropriate target initialization list. * Verify that the IP address entered is correct (BDI2000 configuration). * Inspect the BDM/JTAG signals from the target system for any short-circuits or breaks. * Consider the possibility of damage to the target system.
General| Supported Protocols | JTAG, SWD |
|---|---|
| Target Interface | JTAG, SWD |
| Interface | Ethernet |
| Operating System Compatibility | Windows, Linux |
| Host Interface | Ethernet, USB |
| Supported Architectures/Devices | ARM, MIPS, PowerPC, ColdFire, XScale |
| Connection | Ethernet, USB |
| Debugging Features | Breakpoints, Memory access, Register access |
| Operating System Support | Windows, Linux |
To Next Page
