Analysis is complete in less than four minutes. All results and histograms
are automatically saved in the analyzer’s database.
• When analysis is complete, the analyzer displays all measured and
calculated parameters, as well as the WBC, EOS, RBC, and PLT
histograms:
If the analyzer is not set to print results automatically, press Print to
print the results.
Results falling outside of the specified species reference range are
marked as follows:
• Results above the reference range are flagged and marked with a
plus sign (+).
• Results below the reference range are flagged and marked with a
minus sign (–).
• Warning and error flags are marked with upper- and lower-case letters
at the bottom.
Interpreting Results
Closer to Care.
To Next Page
Loading...
