ABB 615 Series User Manual

Communication Protocol Manual
DNP 3.0
615 series

ABB 615 Series Specifications

General

Frequency	50/60 Hz
Communication	IEC 61850, Modbus, DNP3
Product Type	Protection Relay
Rated Voltage	100-240 V AC
Mounting	DIN Rail
Protection Functions	Overcurrent, Earth Fault, Thermal Overload
Input Voltage	100-240 V AC/DC
Enclosure Class	IP20

Summary

Section 1 Introduction

1.1 This manual

Details the purpose and scope of the communication protocol manual.

1.2 Intended audience

Identifies the target audience and their required knowledge for the manual.

1.3 Protocol documentation

Provides an overview of the documentation set for the IED.

1.4 Document symbols and conventions

Explains symbols and conventions used throughout the document.

Section 2 DNP 3.0 overview

2.1 DNP 3.0 standard

Covers the DNP 3.0 protocol standard, its layers, and functions.

2.2 Documentation

States the DNP 3.0 implementation compliance level.

Section 3 Vendor-specific implementation

3.1 DNP 3.0 link modes

Describes serial and TCP/IP link modes for DNP 3.0.

3.2 DNP 3.0 point list

Details binary input points and control relay output blocks.

3.2.3 Analog inputs

Explains analog inputs, scaling, and fault record timestamps.

3.3 DNP points

Covers point configuration and class assignment for DNP 3.0.

Section 4 DNP 3.0 parameters

4.1 Parameter descriptions

Details link layer and application layer parameters for DNP 3.0.

4.2 Parameter list

Provides a comprehensive list of DNP 3.0 parameters with their settings.

Section 5 Troubleshooting

5.1 Communication checklist

Offers a step-by-step checklist for troubleshooting communication issues.

Section 6 Tolerances

6.1 DNP 3.0 timing considerations

Outlines timing specifications, errors, and delays for DNP 3.0.

Section 7 Glossary