Need help?Do you have a question about the ABB ConVac 7 and is the answer not in the manual?
General| Brand | ABB |
|---|---|
| Model | ConVac 7 |
| Category | Industrial Equipment |
| Language | English |
Explains the operating principle of electrical and mechanical latching.
Lists the voltage ratings (7.2 kV and 12 kV) and versions.
Details characteristics of auxiliary contacts.
Lists standards the contactors comply with.
Explains user responsibility for short-circuit protection.
Instructions for handling with lifting equipment.
Instructions for handling with a crane.
General guidelines for correct installation.
Standards and conditions for installation.
Specifies ambient temperature, humidity, and altitude.
Addresses high altitude and climate fluctuations.
Wiring diagrams for electrical and mechanical latched fixed versions.
Instructions for assembling and connecting the fixed version.
Guidance on connecting auxiliary circuits.
Explains electrical and mechanical latching modes.
General steps and precautions before putting into service.
Overview of maintenance requirements and frequency.
General requirements and procedures for inspection.
Maintenance periods based on operating conditions.
Steps for cleaning surfaces and insulating parts.
Procedure for testing vacuum degree using a VIDAR tester.
Refers to a table of additional maintenance items.
Checks required after short-circuit events.
Inspection for enclosure damage after short-circuit.
Replacing damaged terminals and conductors.
General requirements for fuse replacement.
Preparatory steps before fuse replacement.
Instructions for mounting adapters for DIN fuses.
Steps to remove fuses from DIN fuse holders.
Instructions for mounting adapters for BS fuses.
Steps to install fuses for BS standards.
Lists available spare parts and accessories.
Recommended methods for product disposal.
To Next Page
