Operation Manual / 4 Product description / A100-M axial
Page 19 /
© Copyright 2016 ABB. All rights reserved.
3 Commissioning
3.1 Oil supply
3.1.1 Introduction
In all operating states, a functioning and carefully executed oil supply is an important prerequi-
site for trouble-free operation of the turbocharger.
The lubrication of the turbocharger is usually carried out with oil from the engine oil circulation.
Follow the enginebuilder's specifications on the selection of the lubricating oil and the oil
change intervals.
For more information on the oil supply, refer to Chapter Oil pressure, oil temperature [➙ 23].
3.1.2 Pre-lubrication and post-lubrication
The pre-lubrication time is at least 2 minutes.
The post-lubrication time is 10 minutes.
If the engine is operated in idle mode 10 minutes before stopping, no additional post-
lubrication is required.
Filtering of the lubricating oil with a filter mesh width of ≤ 0.050 mm
is sufficient for the turbo-
charger.
Comply precisely with the oil pressure before the turbocharger for trouble-free operation.
To Next Page
Loading...
Need help?
General
