EasyManuals Logo

ABB ACS150 Installation Instructions

ABB ACS150
4 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
ACS150, ACS310, ACS320, ACS350 and ACS355
MUL1-R1 Installation instructions
WARNING! Before installing MUL1-R1
option, read the safety instructions and
mechanical and electrical installation
mechanical
and
electrical
installation
instructions in the drive user’s manual.
Follow the instructions when installing,
operating and servicing the drive. If
ignored, physical injury or death may
follow, or damage may occur to the
drive motor or driven equipment
1
drive
,
motor
or
driven
equipment
.
Note: You cannot lead the Safe torque off (STO) cable
through the gland plate in the ACS355.
2. Fasten the gland box frame to wall with four M4 screws
(not included).
1. Fasten the gland box frame to drive with two M4×12
screws.
2
7
6
3b
5
4
3a
5, 6, 7. With any fieldbus option module except FRSA-00,
remove the support plate (5) install the I/O clamping plate
3. Install clamps (3a) for control cables (see power cable
lead-throughs), or if cables are run in conduits, replace all
clamps with suitable glands (not included). Run cables
through the clamps and tighten. Strip cable ends. Fasten
the grounding conductor (PE) of the input power cable and
© 2010 ABB Oy. All Rights Reserved. 3AFE68642868 Rev. E / 2010-01-25
4. With FPBA-01 or FCAN-01 option modules, remove the
detachable lid (4) from the gland box cover.
remove
the
support
plate
(5)
,
install
the
I/O
clamping
plate
(6) and the option grounding plate (7) to the gland box
frame. See Mechanical installation in the drive manual.
the twisted shield of motor cable under the grounding
clamps (3b). Connect the conductors to appropriate
terminals. See Electrical installation in the drive manual.
This datasheet has been downloaded from http://www.digchip.com at this page

Other manuals for ABB ACS150

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ABB ACS150 and is the answer not in the manual?

ABB ACS150 Specifications

General IconGeneral
Power Range0.37 to 4 kW
Voltage Range200 to 240 V, 380 to 480 V
Frequency50/60 Hz
Control MethodScalar control
Protection ClassIP20
Frequency Range0 to 500 Hz
Storage Temperature-40 to +70 °C
Relative Humidity5 to 95 % (non-condensing)
Ambient Temperature-10 to +50 °C
I/ODigital inputs, Analog inputs, Relay outputs
Overload Capacity150% for 60 seconds
Braking ChopperBuilt-in (for some models)

Related product manuals