177 ACS2000 AFE 2MVA UM 3BHS355653 ZAB E01 REV. H
6. Holding the phase module at the handles, pull it
out carefully.
7. Disconnect all cables from the Phase-INT circuit
board (1) that are going into the cabinet:
- Auxiliary power supply cable (2)
- Two optical fibers
(3)
The cables are partly concealed by the
grounding strap.
- Current-transformer cable (4).
This cable is only present in phase
modules of the AFE.
8. Detach the cable chain on the side of the phase
module (1, 2).
Pull down the end of the chain a little (3), and
then pull it into the direction of the arrow (4) to
disengage the chain from the mounting
bracket.
9. Fasten the bolt eyes to the phase module.
10. Connect the lifting brackets to the bolt eyes
and lift the phase module using the hoist.
11. Put the new phase module back into the cabi-
net.
To Next Page
Loading...
