ABB ACS2000 DFE - Page 108

108 ACS2000 DFE UM 3BHS360367 ZAB E01 REV. K
The functions of the operator panel include:
• Connecting / disconnecting the main power
supply
• Setting the reference value
• Starting, stopping the drive
• Displaying:
-Actual values
- Status messages
- Alarm and fault messages
• Viewing, setting parameters
• Resetting alarm and fault messages
• Activating the emergency-off circuit
• Testing the bulbs of lamps and illuminated
pushbuttons
8.4.1 Lamp test
The lamp test is activated via the CDP control panel
by setting parameter 16.7 to LAMP TEST. The lamp-
test function resets itself after a set time.
!
For further information on the CDP con-
trol panel, see Chapter 9 - CDP control
panel.