CHAPTER 9 – CDP CONTROL PANEL 121
9.4 Identification mode
The identification mode informs the user about the CDP control panel
version and the ID number of the drive.
The information appears on the display when:
• the power supply is switched on, or
• the CDP control panel is connected to the drive
and the auxiliary voltage has been switched on
already.
When the CDP control panel is initialized as
described before, the display changes as follows:
After 2-3 seconds, information on the drive (1, 2),
the application software in use (3), and the drive
identification (4) is displayed.
After another few seconds:
CDP312 PANEL V5.30
........
ACS2000 xxxx
< Device Name >
ID-NUMBER 1
LDAI5500
1
3
2
4
1 L ->
0.0 rpm
StateINU
InitSeq....
MOTOR SP 0.00 rpm
POWER
0.0 kW
To Next Page
Loading...
