26 ACS2000 DFE UM 3BHS360367 ZAB E01 REV. K
1.5 Cyber Security Requirements
1.5.1 Cyber Security Disclaimer
This product is designed to be connected to and to
communicate information and data via a network
interface.
It is Customer's sole responsibility to provide and
continuously ensure a secure connection between
the product and Customer network or any other
network (as the case may be). Customer shall
establish and maintain any appropriate measures
(such as but not limited to the installation of fire-
walls, application of authentication measures,
encryption of data, installation of anti-virus pro-
grams, etc) to protect the product, the network, its
system and the interface against any kind of secu-
rity breaches, unauthorized access, interference,
intrusion, leakage and/or theft of data or informa-
tion.
ABB and its affiliates are not liable for damages
and/or losses related to such security breaches,
any unauthorized access, interference, intrusion,
leakage and/or theft of data or information.
1.5.2 User Lock
For better cyber security, it is highly recommended
that you set a master pass code to prevent e.g. the
changing of parameter values.
To activate the user lock for the first time, enter
the default pass code, 358, into
16.02 Passcode
.
This will make parameters
16.16…16.17
change-
able. Then enter the old pass code to
16.16 OldUs-
erPasscode
and change user pass code in
16.17
NewUserPasscode
. In
16.02 Parameter Lock
, the
user lock functionality can now be enabled.
ABB will not be liable for damages or losses caused
by the failure to activate the user lock using a new
pass code. See 1.5.1 Cyber Security Disclaimer.
To Next Page
Loading...
