ABB ACS580-01 - Configuration and Final Steps

16 EN – Main switch and EMC C1 filter options installation supplement
EN
DA
DE
ES
FI
FR
IT
NL
PL
PT
RU
SV
TR
ZH
Installation
 Do according to the R1…R5 quick installation and start-up guide of
the drive
• Check if capacitors need to be reformed.
• Select the power cables.
• Ensure the cooling.
• Protect the drive and input power cable with suitable fuses.
•R1…R2:
Open the cover by removing one screw on each side.
•R3:
Open the top cover by removing two screws on each side and then the cable
box cover by removing two screws on each side.
•R4: Open the top cover by removing three screws on each side and then the
cable box cover by removing two screws on each side.
•R5:
Open the top cover by removing five screws on each side and the cable box
cover by removing two screws on each side.
Note: If the drive has a main switch (+F278 or +F316), it must be in the OFF
position (see the figure below) to be able to open the cable box cover.
• Install the drive on the wall.
OFF