Mechanical installation of non-pre-assembled units (ACS800-04M)
105
3
Fastening
the adapter
to the drive
module
- 1.See Fastening the adapter to the drive module on
page 109.
2.Go to step 4.
4
Fastening
the pedestal
by the base
(not performed
for wall-
mounted units)
Base mounting
from outside
1.See Clamping the pedestal with the outside brackets
on page 80.
2.Go to step 5.
Base mounting
from inside
1.See Fastening the pedestal through the holes inside
the pedestal on page 80.
2.Go to step 5.
5
Fastening
the adapter
to the
pedestal
- 1.See Fastening the drive module to the pedestal via
the adapter on page 110.
2.Go to step 6.
6
Connecting
the output
busbars
Units with vertical
busbars
1.See Connecting the output busbars on the short side
of the module on page 111.
2.Go to step 7.
7
Wall
mounting
(not
performed for
base-mounted
units)
wall-mounted unit 1.See Fastening the drive module to wall (wall-
mounted units only, not for base-mounted units) on
page 81.
8
Fastening by
top
base-mounted
unit
1.See Fastening the drive module by top to the cabinet
frame on page 81.
Step If Instruction
To Next Page
Loading...
