Need help?Do you have a question about the ABB ACS800 Series and is the answer not in the manual?
General| Product Series | ACS800 |
|---|---|
| Cooling Method | Air-cooled, Liquid-cooled |
| Rated Power | 0.55 to 5600 kW |
| Voltage Range | -15% to +10% |
| Enclosure Class | IP21, IP55 |
| Control Method | Direct Torque Control (DTC) |
| Communication Protocols | Modbus, CANopen, Ethernet |
| Protection Features | Overcurrent, Overvoltage, Undervoltage, Short Circuit, Ground Fault |
| Storage Temperature | -40 to +70 °C |
| Humidity | Less than 95% (non-condensing) |
| Altitude | Up to 1000 m without derating, up to 4000 m with derating |
| Type | Industrial AC Drive |
| Operating Temperature | -10 to +50 °C (depending on enclosure and derating) |
Instructions for following safety guidelines and reading relevant manuals.
Steps for safe start-up, including applying mains power and panel display sequence.
Detailed steps for performing the Standard ID Run, including parameter checks.
How to navigate and change parameter values using the panel.
Procedure for accessing and clearing the drive's fault history logs.
Explains the two primary modes of drive control and their sources.
Explains the process of motor model identification for optimal control.
Protects the motor against stalling by monitoring limits.
A step-by-step checklist for setting up the Master/Follower function quickly.
Explains tension regulation using loadcell feedback and adaptive P-Gain.
Data words indicating alarms, faults, limits, and status.
To Next Page
