ABB ACS800 Series - Block Diagram: Start, Stop, Direction Source for EXT1; Block Diagram: Reference Source for EXT1

Program features
25
Block diagram: start, stop, direction source for EXT1
The figure below shows the parameters that select the interface for start, stop, and
direction for external control location EXT1.
Block diagram: reference source for EXT1
The figure below shows the parameters that select the interface for the speed
reference of external control location EXT1.
CH0 / RDCO board
KEYPAD
EXT1
XT DI1
COMM.
MODULE
Control panel
Start/stop
DI1 / Std IO = Digital input DI1 on the standard I/O terminal block
DI1 / DIO ext 1 = Digital input DI1 on the Digital I/O Extension Module 1 (XT DI1 in Parameters)
10.01
Select
Fieldbus Adapter Slot1
DI1 / Std IO
DI2 / Std IO
DI1 / DIO EXT 1
DI1, DI2
I/O Extensions
See parameter
group 98 OPTION
MODULES
Fb. selection
See chapter
Fieldbus control
EXT1
AI1 / Std IO
AI1 / AIO ext
11.03
Select
C
H0 / RDCO board
KEYPAD
COMM.
MODULE
Control panel
AI2 / Std IO
AI3 / Std IO
AI1, AI2, AI3
XT AI1
REF1 (rpm)
Reference
AI1 / Std IO = analog input AI1 on the standard I/O terminal block
AI1 / AIO ext = analog input AI1 on the Analog I/O Extension Module (AI5 in Parameters)
I/O Extensions
See parameter
group 98 OPTION
MODULES
Fb. selection
See chapter
Fieldbus control