ABB ACS800 Series - How to Adjust a Source Selection (Pointer) Parameter

Control panel
17
How to adjust a source selection (pointer) parameter
Most parameters define values that are used directly in the drive application
program. Source selection (pointer) parameters are exceptions: They point to the
value of another parameter. The parameter setting procedure differs somewhat from
that of the other parameters.
Note: Instead of pointing to another parameter, it is also possible to define a
constant by the source selection parameter. Proceed as follows:
- Change the inversion field to C. The appearance of the row changes. The rest of
the line is now a constant setting field.
- Give the constant value to the constant setting field.
- Press Enter to accept.
Step Action Press Key Display
1. See the table above to:
- enter the Parameter Mode
- select the correct parameter group
and parameter
- enter the parameter setting mode
ENTER
1 L ->1242.0 rpm O
84 ADAPTIVE PROGRAM
06 INPUT1
[±000.000.00]
2. To scroll between the inversion,
group, index and bit fields.
1 L ->1242.0 rpm O
84 ADAPTIVE PROGRAM
06 INPUT1
[±000.000.00]
3. To adjust the value of a field. 1 L ->1242.0 rpm O
84 ADAPTIVE PROGRAM
06 INPUT1
[±000.018.00]
4. To accept the value.
PAR
ENTER
Inversion field inverts the selected parameter value.
Plus sign (+): no inversion
Bit field selects the bit number (relevant only if the
parameter value is a packed boolean word).
Index field selects the parameter index.
Group field selects the parameter group.
Minus (-) sign: inversion.
1 L -> 1242.0 rpm O
84 ADAPTIVE PROGRAM
06 INPUT1
[ 001.018.00]
Inversion field
Group field
Index field
Bit field