ABB ACS800 Series - Inertia Control

Actual signals and parameters
116
0.0…22.0% Setting range. 10 = 1%
63.30 STALL P-GAIN Proportional gain of the dancer PI regulator when in stall mode.
0.01…1000.00 K Setting range. 100 = 1 K
63.31 STALL INTEG Integration time of the dancer PI regulator when in stall mode.
10…10000 ms Setting range 1 = 1 ms
63.32 TEN CTRL ENBL PTR Defines the source or constant for selection PARAM 63.32 of
63.09 TENSION CTL ENABLE.
-255.255.31…+255.255.31
/ C.-32768…C.32767
Parameter index or a constant value. See 10.05 EXT STRT PTR for
information on the difference.
-
63.33 TEN SETPT PTR Defines the source or constant for selection PARAM 63.33 of
63.10 TENSION SETPOINT.
-255.255.31…+255.255.31
/ C.-32768…C.32767
Parameter index or a constant value. See 10.05 EXT STRT PTR for
information on the difference.
-
63.34 TEN FDBK PTR Defines the source or constant for selection PARAM 63.34 of
63.11 TENSION FDBK INPUT.
-255.255.31…+255.255.31
/ C.-32768…C.32767
Parameter index or a constant value. See 10.05 EXT STRT PTR for
information on the difference.
-
64 INERTIA CONTROL
Inertia compensation control and setup.
Note: This group is hidden unless 60.01 INERTIA COMP ENBL is
YES.
64.01 INERTIA ON IN SPD Enables inertia compensation when in speed mode instead of only in
torque.
NO Disabled. 0
YES Enabled. 65535
64.02 SHAFT WEIGHT Weight of the shaft.
1.0…9999.0 kg
1.0…9999.0 lb
Setting range. 10 = 1 kg
10 = 1 lb
64.03 SHAFT OUTER DIA Outer diameter of the shaft the core is “on”.
1.0…99999.0 mm
1.0…99999.0 inch
Setting range. 10 = 1 mm
10 = 1 inch
64.04 SHAFT INNER DIA Inner diameter of the shaft the core is “on”.
0…99999.0 mm
0…99999.0 inch
Setting range. 10 = 1 mm
10 = 1 inch
64.05 WEB1 DENSITY x100 Density of the web material x 100.
1.0…9999.0 g/cm
3
1.0…9999.0 lb/in
3
Setting range. 10 = 1 g/cm
3
10 = 1 lb/in
3
64.06 WEB2 DENSITY x100 Optional density of the web material x 100.
1.0…9999.0 g/cm
3
1.0…9999.0 lb/in
3
Setting range. 10 = 1 g/cm
3
10 = 1 lb/in
3
64.07 WEB1 WIDTH Web width.
0…9999 mm
0…9999 inch
Setting range. 1 = 1 mm
1 = 1 inch
64.08 WEB2 WIDTH Optional web width.
0…9999 mm
0…9999 inch
Setting range. 1 = 1 mm
1 = 1 inch
No. Name/Value Description FbEq