Control panel
18
Function mode
In the Function Mode, the user can:
• copy the drive parameter values and motor data from the drive to the panel.
• copy group 1 to 97 parameter values from the panel to the drive.
1)
• adjust the contrast of the display.
The panel enters the Function Mode when the user presses the FUNC key.
How to copy data from a drive to the panel
Note:
• Uploading must be completed before downloading.
• The uploading and downloading are possible only if the program versions of the
destination drive are the same as the versions of the source drive, see 33.01
SOFTWARE VERSION and 33.02 APPL SW VERSION.
• The drive must be stopped during the downloading.
Step Action Press Key Display
1. Set-up the drives. In each drive, activate
the communication to the optional
equipment. See parameter group 98
OPTION MODULES.
2. In one drive, set the parameters in
groups 10 to 97 as preferred.
3. Enter the Function Mode. 1 L -> 1242.0 rpm O
U
PLOAD <=<=
DOWNLOAD =>=>
CONTRAST 4
4. Select the upload function (a flashing
cursor indicates the selected function).
1 L -> 1242.0 rpm O
U
PLOAD <=<=
DOWNLOAD =>=>
CONTRAST 4
5. Enter the upload function. 1 L -> 1242.0 rpm O
UPLOAD <=<=
6. Switch to external control.
(No L on the first row of the display.)
1 -> 1242.0 rpm O
U
PLOAD <=<=
DOWNLOAD =>=>
CONTRAST 4
7. Disconnect the panel and reconnect it to
the drive into which the data will be
downloaded.
1)
The parameter groups 98, 99 and the results of the motor identification are not included as default.
The restriction prevents downloading of unfit motor data. In special cases it is, however, possible to
download all. For more information, please contact your local ABB representative.
FUNC
ENTER
LOC
REM
To Next Page
Loading...
