Control panel
9
Control panel
Chapter overview
The chapter describes how to control, monitor and change the settings of the drive
using the control panel CDP 312R.
The same control panel is used with all ACS800 series drives, so the instructions
given apply to all ACS800 types. The display examples shown are based on the
Standard Control Program; displays produced by other control programs may differ
slightly.
Overview of the panel
The LCD type display has 4 lines of 20 characters.
The language is selected at start-up by parameter 99.01.
The control panel has four operation modes:
- Actual Signal Display Mode (ACT key)
- Parameter Mode (PAR key)
- Function Mode (FUNC key)
- Drive Selection Mode (DRIVE key)
The use of single arrow keys, double arrow keys, and ENTER
depend on the operation mode of the panel
The drive control keys:
No. Use
1Start
2Stop
3 Activate reference setting
4 Forward direction of rotation
5 Reverse direction of rotation
6 Fault reset
7 Change between Local / Remote (external) control
1 L -> 1242.0 rpm I
F
REQ 45.00 Hz
CURRENT 80.00 A
POWER 75.00 %
ACT PAR FUNC DRIVE
ENTER
LOC RESET R EF
REM
I0
1
2
3
4 5
67
To Next Page
Loading...
