Program features
24
External control
When the drive is in external control, the commands are given through the control
terminal block on the standard I/O board (digital and analog inputs), optional I/O
extension modules and/or CH0 Fieldbus Adapter. In addition, it is also possible to
set the control panel as the source for the external control.
External control is indicated by a blank on the panel display or with an R in those
special cases when the panel is defined as a source for external control.
Settings
Panel Key Additional Information
LOC/REM Selection between local and external control
Parameter
10.01 Start and stop source for EXT1
10.02 Direction source for EXT1
11.03 Reference source for EXT1
Group 98 OPTION MODULES Activation of the optional I/O and serial communication
External Control through the Input/
Output terminals, or through the
fieldbus interfaces
1 R ->1242 rpm I 1 ->1242 rpm I
External Control by control panel
To Next Page
Loading...
