Application macros
62
User macros
In addition to the standard application macros, it is possible to create two user
macros. The User macro allows the user to save the parameter settings including
Group 99, and the results of the motor identification into the permanent memory, and
recall the data at a later time. The panel reference is also saved.
To create User macro 1:
• Adjust the parameters. Perform the motor identification if not performed yet.
• Save the parameter settings and the results of the motor identification by
changing 99.02 APPLICATION MACRO to USER 1 SAVE (press ENTER). The
storing takes 20 s to 1 min.
Note: If user macro save function is executed several times, drive memory fills up
and file compression starts. File compression can last up to 10 minutes. Macro
saving will be completed after the file compression. (Operation is indicated on the
last row of the control panel display by blinking dots).
To recall the User macro:
• Change 99.02 APPLICATION MACRO to USER 1 LOAD.
• Press ENTER to load.
The User macro can also be switched via digital inputs (see 16.05 USER MACRO IO
CHG).
Note: User macro load restores also the motor settings in group 99 START-UP
DATA and the results of the motor identification. Check that the settings correspond
to the motor used.
Example: The user can switch the drive between two motors without having to
adjust the motor parameters and to repeat the motor identification every time the
motor is changed. The user needs only to adjust the settings and perform the motor
identification once for both motors and then to save the data as two user macros.
When the motor is changed, only the corresponding User macro needs to be loaded,
and the drive is ready to operate.
To Next Page
Loading...
