Mechanical installation of non-pre-assembled units (ACS800-04M)
54
3. Fasten the bottom plate to the base of the drive module.
4. Fasten the front cover.
A. With brake chopper option (+D150), fasten R- busbar to the
bottom plate with pin A1.
B. Insert the bottom plate onto its place.
C. Connect the busbars of the bottom plate to the busbars of the
drive module with M8x25 combi screws using a torque wrench
with an extension bar. Tightening torque: 15...22 Nm
(11...16 lbf ft).
D. Fasten the bottom plate to the drive module with four M6
screws. Tightening torque: 6...9 Nm (3.7 lbf ft).
B
C
C
C
C
C
U2
R+/UDC+
D
D
A
A1
C
W2
V2
R-
UDC-
D
To Next Page
Loading...
