ABB ACS880-1604 - 10 Ordering Information; Contents of this Chapter

Ordering information 119
10
Ordering information
Contents of this chapter
This chapter lists the types and ordering codes of the ACS880-1604 DC/DC converter unit
components. The data is valid for ACS880-1604 DC/DC converter modules and related
accessories.
You can find the kit-specific assembly drawings, step-by-step instructions and detailed kit
information on the Internet. Go to https://sites-
apps.abb.com/sites/lvacdrivesengineeringsupport/content. If needed, contact your local
ABB representative.
Notes:
• This chapter only lists the installation accessories available from ABB. All other parts
must be sourced from a third party (such as Rittal) by the system integrator. For a
listing, refer to the kit-specific installation instructions available at https://sites-
apps.abb.com/sites/lvacdrivesengineeringsupport/content. For access, contact your
local ABB representative.
• Parts that are labeled suitable for generic enclosures are not designed for any specific
enclosure system. These parts are intended as a basis for further engineering, and
may require additional parts to be fully usable.
Installation accessories designed for generic enclosures are in fact designed for an
inside width of 50 mm less than the nominal width of the enclosure. For example, a
mechanical kit intended for 800 mm wide generic enclosure is designed for an inside
width of 750 mm, and will not fit a 800 mm wide Rittal TS 8 enclosure.