Cabinet construction 41
Installation examples
WARNING! The code labels attached to mechanical parts such as
busbars, shrouds and sheet metal parts must be removed before
installation as they may cause bad electrical connections, or, after
peeling off and collecting dust in time, cause arcing or block the cooling air flow.
This section includes installation examples of the DC/DC converter modules in the Rittal
TS 8 enclosure.
Each example includes a table that lists:
• installation stages of different equipment in the order in which the installation into the
cabinet should be performed
• code of the step-by-step instructions
• equipment kit code
• kit ordering code.
You can find the kit-specific assembly drawings, step-by-step instructions and kit
information on the Internet. Go to https://sites-
apps.abb.com/sites/lvacdrivesengineeringsupport/content. If needed, contact your local
ABB representative.
The example includes also cabinet assembly drawings that show each stage listed in the
table. More detailed steps of each stage are described in the kit-specific assembly
drawings.
For general instructions, see Cabinet design and construction instructions for ACS880
multidrive modules [3AUA0000107668 (English)].
To Next Page
Loading...
