Joining cabinet sections together
Wide cabinet line-ups are delivered in multiple sections. The sections must be joined
together at the installation site. There is a joining cubicle at the end of a section for
this purpose. The screws for joining the sections are in a plastic bag inside the cabinet.
1. Attach the first section to the floor.
2. Remove any plates covering the rear post of the joining cubicle.
3. Align the two sections. The illustration below shows the placement of the sections.
First sectiona
Joining cubicleb
Second sectionc
4. Attach the front and rear posts of the joining cubicle to the posts of the other
section with 16 screws (8 per post). Tighten the screws to 5 N·m (3.7 lbf·ft).
5. Attach the second section to the floor.
Mechanical installation 19
To Next Page
Loading...
