ABB AMA Series - Chapter 1 - Introduction; 1.1 General information; 1.2 Important note; 1.3 Limitation of liability

Manual for Induction Motors and Generators
- 1
3BFP 000 050 R0101 REV E
Chapter 1 - Introduction
1.1 General information.................................................................................................... 1
1.2 Important note............................................................................................................. 1
1.3 Limitation of liability.................................................................................................. 2
1.4 Documentation............................................................................................................ 2
1.4.1 Documentation of the machine.................................................................. 2
1.4.2 Information not included in documentation............................................... 3
1.4.3 Units used in this User’s Manual............................................................... 3
1.5 Identification of the machine...................................................................................... 3
1.5.1 Serial number of the machine.................................................................... 3
1.5.2 Rating plate................................................................................................ 3
Chapter 2 - Transport and Unpacking
2.1 Protective measures prior to transport ........................................................................ 6
2.1.1 General....................................................................................................... 6
2.1.2 Bearing plate.............................................................................................. 6
2.2 Lifting the machine..................................................................................................... 8
2.2.1 Lifting a machine in a seaworthy package................................................. 8
2.2.2 Lifting a machine on a pallet ..................................................................... 9
2.2.3 Lifting an unpacked machine................................................................... 10
2.3 Turning a vertically mounted machine ..................................................................... 11
2.4 Checks upon arrival and unpacking.......................................................................... 12
2.4.1 Check upon arrival................................................................................... 12
2.4.2 Check upon unpacking............................................................................. 12
2.5 Installation instructions for main terminal box and cooler parts .............................. 12
2.5.1 Installation of main terminal box............................................................. 12
2.5.2 Installation of cooler parts ....................................................................... 13
2.6 Storage ...................................................................................................................... 13
2.6.1 Short term storage (less than 2 months)................................................... 13
2.6.2 Long term storage (more than 2 months)................................................. 14
2.6.3 Rolling bearings....................................................................................... 15
2.6.4 Sleeve bearings ........................................................................................ 17
2.6.5 Openings.................................................................................................. 18
2.7 Inspections, records .................................................................................................. 18
Chapter 3 - Installation and Alignment
3.1 General...................................................................................................................... 19
3.2 Foundation design..................................................................................................... 19
3.2.1 General..................................................................................................... 19
3.2.2 Forces to the foundation .......................................................................... 20
3.2.3 Flanges for vertically mounted machines................................................ 20
3.3 Machine preparations before installation.................................................................. 20
3.3.1 Insulation resistance measurements......................................................... 20
3.3.2 Disassembly of the transport locking device........................................... 21
3.3.3 Coupling type........................................................................................... 21
3.3.4 Assembly of the coupling half................................................................. 21
3.3.4.1 Balancing of coupling....................................................... 21
3.3.4.2 Assembly........................................................................... 22
3.3.5 Belt drive.................................................................................................. 22