ABB CalMaster2 - Fitting an Aquamaster Pulsed Output Socket with Serial Communications

Field and Software Tools
CalMaster2 and CheckMaster 3 Installation
IM/VCM2 Issue 6 15
3.3.5 Fitting an AquaMaster Pulsed Output Socket with Serial Communications
To fit an AquaMaster pulsed output socket with serial communications:
1. Turn off the power to the AquaMaster and remove the covers – see Section 3.3.2, page 12.
2. Disconnect and withdraw the pulsed output cable A.
3. Remove and discard the gland B.
4. Feed the socket lead into the AquaMaster and fit the socket (MGFA0609-O) C.
5. Connect the sensor cable D.
6. Replace the covers – see Fig. 3.7, page 12.
Fig. 3.10 Fitting an AquaMaster Pulsed Output Socket with Serial Communications
O/P COM
O/P1
O/P2
GND
RI
CTS
RTS
TXD
RXD
Grey/Blue
Orange
Blue
Green
Yellow
Yellow/Red
Red/Black
Brown
Violet/Red
B
C
D
A