ABB Comem DTI

14
TEMPERATURE MONITORING DEVICE COMEM DTI AND COMEM EDTI - INSTRUCTION MANUAL
—
6. Programming of the device
Baud rate setting  
 BDR 
 BDR 
 BDR 
 BDR 
6.6 Selection of address network identification for
the communication of the serial port
(MODBUS-RTU protocol)
6.7 Selection of the baud rate
THIS SETTING IS SIGNIFICANT ONLY FOR
COMEM EDTI MODEL.
THIS SETTING IS SIGNIFICANT ONLY FOR
COMEM EDTI MODEL.
NOTE
NOTE
This setting is indicated on displays with:
• value to set on T1-T2 display
• ID on T3-T4 display.

The range for accepted value is from 1 to 247.
Confirm with ENTER.
This setting is indicated on displays with:
• BDR on T1-T2 display
• value to set on T3-T4 display.

It’s possible to choose between the following values: 2,4 - 4,8 - 9,6
19,2 kbps.
Confirm with ENTER.
Modbus setting  
Setting address MODBUS network  ID