16
TEMPERATURE MONITORING DEVICE COMEM DTI AND COMEM EDTI - INSTRUCTION MANUAL
6.9 Selection of the linked channel with the
analogue output
THIS SETTING IS SIGNIFICANT ONLY FOR
COMEM EDTI MODEL.
NOTE
This setting is indicated on displays with:
• AN on T1-T2 display
• the linked measure channel on T3-T4 display: CH 1/2/3/4 for the
1/2/3/4 measure channel, ALL to link the measure channel with
the higher temperature.
Confirm with ENTER.
Link channel setting
Channel with higher temperature AN ALL
AN
AN
AN
AN
—
6. Programming of the device
To Next Page
Loading...
