ABB Commander C1900 - Basic Configuration Parameters

C1900 | CIRCULAR CHART RECORDER | CI/C1900/REC-EN REV. B 15
Basic configuration
SEtUP INPUt
Set Up Input
Input Type (PV) Temperature Units
ENG–LO ____ dEC–Pt ____
rNG–HI _.__
Input Range High
INtYP ____
Set Up Inputs
UNItS ____
ENG–HI ____
Input Range Low
FdLP _.__
Fault Detection Level Programmable Filter
PrGFLt _.__
bSPd ____
Broken Sensor Drive
rNG–LO _.__
Select Channel
SELECt ____
Engineering High
Decimal Point
Engineering Low
Linearizer Type
LNtYP ____
Select Output
Output Range High Output Range Low Output Source
Set Up Analog Output *
SELECt ____
Set Up Output
SEt UP ANALOG
Retrans. Range Hi
Retrans. Range Low
HI–OP ____
LO–OP ____
OP–SrC ____
rNG–HI ____
rNG–LO ____
dIGtAL INPUtS
Digital Inputs
Digital Inputs *
Polarity
POLrtY ___
Select Digital I/P
SELECt ____
CHArt ____
Chart Time
Stop Chart Signal
Set Up Chart
Set Up Chart
SEtUP CHArt
CH–StP ______
Auto Pen Drop
AUtdrP ___
Pen Lift Enable
LFt EN ___
Pen Lift/Pen Status
PENLFt ____
OPrtOr
LEVEL
bASIC
CONFIG
Basic Config Operator Level
Select PV/Pen/Filter
Scale Reset Offset Adjustment Cal. Pen At 100% Cal. Pen At 0% Span Adjust
Scale Adjust
SELECt ____ rESEt __
OFFSEt ____
SPAN ____ SEtPEN At 100
Scale Adjust
SCALE AdJUSt
SEtPEN At 0
Check Pen Cal.
CHECK __._
Mains Filter
FILtEr __ Hrt
Set Up Digital Output
Select Output
SELECt ____
Output Source Digital Outputs
dIGtAL OUtPtS
SOUrCE ____
Polarity
POLrtY ____
AdVNCd CONFIG
Advanced Config
Set Up Relay Output
Select Relay Output
SELECt ____
Relay Source Set Up Output
SEt UP rELAYS
SOUrCE ____
Polarity
POLrtY ____
Set Up Pen Range
Select Pen
Pen Range High
Pen Range Low In Source
SEtUP PENrNG
Set Up Pen Range
SELECt ____
PEN–HI ____
PEN–LO ____
Out Source
IN SrC ______ OUt.SrC _____
SEtUP ALArMS
Set Up Alarms Acknowledge Type
SELECt __
Select Alarm
trIP ____
Trip Level
Set Up Alarms
HYSt ____
Hysteresis
tYPE ____
Alarm Type
ACKtYP ____ t–HYSt ____
Time Hysteresis
ACKSrC _____
Alarm Ack Source
dELAY
____
Alarm Delay
EN-Sr-C
____
Enable Source
ACCESS PAGE
Access Page
Access Page
Configure Password
C–PASS ____
PEN-AJ
____
Pen Adjust Enable
PA-PAS
____
Pen Adj. Password
* Not applicable to C1901J (non-upgradeable version)