ProcessMaster FEP610, HygienicMaster FEH610 | OI/FEP610/FEH610-EN Rev. B 23
5.5.3 Connection using a cable conduit
Fig. 33: Installation set for cable conduit
NOTE
Condensate formation in terminal box
If the flowmeter sensor is connected to cable conduits, there
is a possibility that humidity may get into the terminal box
because of condensate formation in the cable conduit.
Ensure that the cable entry points on the terminal box are
sealed.
An installation set for sealing the cable conduit is available via
order number 3KXF081300L0001.
5.5.4 Connection with IP rating IP 68
Fig. 34
1 Maximum flooding height 5 m (16.4 ft)
For sensors with IP rating IP 68, the maximum flooding height
is 5 m (16.4 ft). The supplied cable fulfills all submersion
requirements.
The sensor is type-tested in accordance with EN 60529. Test
conditions: 14 days at a flooding height of 5 m (16.4 ft).
Connection
NOTE
Potential adverse effect on IP rating IP 68!
The IP rating IP 68 of the sensor may be adversely affected
as a result of damage to the signal cable.
The sheathing of the signal cable must not be damaged.
1. Use the supplied signal cable to connect the sensor and
the transmitter.
2. Connect the signal cable in the terminal box of the sensor.
3. Route the cable from the terminal box to above the
maximum flooding height of 5 m (16.4 ft).
4. Tighten the cable gland.
5. Carefully seal the terminal box. Make sure the gasket for
the cover is seated properly.
NOTE
As an option, the sensor can be ordered with the signal
cable already connected to the sensor and the terminal box
already potted.
G12036
G10171
1
To Next Page
Loading...
