ABB NGC Series - User Manual

NGC SERIES/PGC 1000 QUICK START GUIDE| 2106235MNAB-001
Comm1 and Comm 2 Pinouts/Terminations
PIN
RS-232
RS-485
RS-422
COMM 1 (J8)
COMM 1 (J8)
COMM 1 (J8)
1
Power Out
Power Out
Power Out
2
Ground
Ground
Ground
3
Switched Power Out
Switched Power Out
Switched Power Out
4
Operate
Operate
Operate
5
Not Used
RRTS
RTS
6
Request To Send
Bus +
Transmit Bus +
7
Transmit Data
Bus -
Transmit Bus -
8
Receive Data
No Connection
Receive Bus +
9
Clear To Send (CTS)
No Connection
Receive Bus -
COMM 2 (J10)
COMM 2 (J10)
COMM 2 (J10)
1
Power Out
Power Out
Power Out
2
Ground
Ground
Ground
3
Switched Power Out
Switched Power Out
Switched Power Out
4
Operate
Operate
Operate
5
Not Used
RRTS
RTS
6
Request To Send
Bus +
Transmit Bus +
7
Transmit Data
Bus -
Transmit Bus -
8
Receive Data
No Connection
Receive Bus +
9
Clear To Send (CTS)
No Connection
Receive Bus -
TERMINATIONS
Comm 1 (J9)
Comm 2 (J11)
First or intermediate unit
(RS-485)
Pins 2
–3
Pins 2
–3
Last or only unit
(RS-485)
Pins 1
–2
Pins 1
–2
RS
-232
Pins 2
–3
Pins 2
–3
Figure 1: Tubing layout
#
Name
1
Carrier gas
2
Cal gas
3
Feed through
assembly
4
Sample
conditioning
module
5
Sample probe
6
Vent lines
Figure 2: NGC and PGC 1000 Terminal Board
ABB MEASUREMENT & ANALYTICS
NGC series and PGC 1000
Quick Start Guide
Save this guide. Use the code on the back to access
user manuals and other product information.
Safety and compliance information is included with
the device in the shipping packaging.
We reserve the right to make technical changes or
modify the contents of this document without prior
notice. Regarding purchase orders, agreements
shall prevail. ABB does not accept any responsibility
whatsoever for potential errors or possible lack of
information in this document.
Teflon™ is a registered trademark of Chemours.
Sulfinert
®
is a registered trademark of Restek.
Copyright
©
2020 ABB all rights reserved

ABB NGC Series Specifications

General

Power Supply	24 V DC
Communication Protocols	HART, Modbus
Hazardous Area Certifications	ATEX, IECEx
Measurement Range	0-100% for most components, varies by component and model
Output	4-20 mA
Protection Rating	IP66
Operating Temperature	-20°C to +50°C

Summary

Connect sample streams

Common Settings

Set carrier regulator to 90 PSIG and calibration blend/sample stream pressures to 5-20 PSIG.

Power supply information

Details for 12-volt and 24-volt power supplies, including amps and voltage settings.

Startup using USB

Step-by-step guide for initiating unit startup and configuration via a USB connection.

TCP connection

Instructions for setting up a TCP connection, referring to the user manual for details.

Contact us

ABB contact information for technical support, quotes, orders, and training.