Need help?Do you have a question about the ABB Navigator 600 Series and is the answer not in the manual?
General| Measurement Parameters | pH, ORP, Conductivity, Resistivity, TDS, Salinity, Temperature |
|---|---|
| Measurement Range pH | 0 to 14 pH |
| Measurement Range ORP | -2000 to +2000 mV |
| Power supply | 100 to 240 VAC, 50/60 Hz or 24 VDC |
| Output signal | 4 to 20 mA |
| Communication | Modbus |
| Measurement Range Conductivity | 2000 mS/cm |
| Measurement Range Temperature | -20 to 130°C (-4 to 266°F) |
| Display | LCD, backlit |
| Dimensions | 144 x 144 mm |
Manufacturer-independent, open fieldbus standard for automation.
High-speed data exchange protocol for complex devices.
Protocol for process automation devices requiring intrinsic safety.
Information on ABB's use of Profibus DP for Navigator 600 Series analyzers.
Details the RS485 transfer method and bus structure.
Explains the bus structure and segment limitations.
Specifies maximum segment lengths based on transmission speed.
Details the required characteristics for Profibus cable.
Explains the role of GSD files for device configuration.
Illustrates network cable connections to the Profibus board.
Details how to configure Profibus communications via the analyzer's keypad.
Defines Module 01 data for Profibus cyclic transfer.
Explains the meaning of the analyzer's status byte codes.
Details parameters related to the device's physical characteristics.
Lists parameters for transducer-specific functions.
Table listing diagnostic data and status indications.
Table detailing extended diagnostic data and status indications.
Overview of ABB's product categories and industries served.
Details of ABB's worldwide service and support network.
Information and requirements regarding product warranty.
To Next Page
