Menu: Device Setup (continued)
Menu/Parameter Value Range Description
Device Setup/Device
Variables/Volume Level
Lower Range
Upper Range
Device Setup/Device Variables/
Volume Interface
Lower Range
Upper Range
Device Setup/Device Variables/Flow
Lower Range
Upper Range
Device Setup/Linearization/Setup
Table State Enabled, Disable
Input Units mm, cm, m, in, fit
Output Type Level, volume, flow
Output Units • Unit length
- mm, cm, m, in, ft
• Unit volume
- Liters, Cubic meters, cubic inches, cubic feet, cubic
yards, gallons, Imperial gallons, bushels, barrels,
liquid barrels
• Unit flow
- Liters/second, liters/minute, liters/hour, gallons/
second, gallons/minute, gallons/ hour, gallons/day,
imperial gallons/ second, imperial gallons/minute,
imperial gallons/hour, imperial gallons/day,
barrels/second, barrels/minutes, barrels/ hour,
barrels/day, cubic meters/second, cubic meters/
minute, cubic meters/hour, cubic meters/day, cubic
feet/second, cubic feet/minute, cubic feet/hour,
cubic feet/day
Minimum
Maximum
Device Setup/Linearization/Points
Input Point
Output Point
Enable/Disable
Device Setup/Linearization/
Configure Tables
Clear
Save
Restore
Device Setup/Device Configuration
Device Configuration
Device Setup/Mount Orientation
Mount Orientation Top, Bottom This is the mounting orientation of the sensor
Device Setup/Access Control
Standard Password Alphanumeric User defined
Advanced Password Alphanumeric User defined
Service Password Restricted Restricted
Reset to Defaults
Save as default
Reset to factory
To Next Page
Loading...
