Controls and Display
Upper display gives continual update of flow rate in
selected units.
By pressing the key, the lower display steps through
the following sequence:
> Forward flow total value.
< Reverse flow total value
* Net flow total value
Alm Active alarms – Any alarms are displayed
sequentially if more than one alarm is present.
'Alm Clr' is displayed when no alarms are present.
Vel Flow Velocity
% % of Flow Range.
Pressing the key resets the flow total displayed on the
upper display, if parameter 'Tot Clr En' is enabled.
Pressing the key accesses the Login Parameter
where it is necessary to enter a security code before any
other parameters can be accessed – see SECURITY
ACCESS.
CONTROLS AND DISPLAY
MENU LAYOUT
…MENU LAYOUT
Two security code levels, 1 and 2, are available, and are
each accessed with a five digit number.
User Code Level 1 default number is 10760.
Engineer Code Level 2 default number is 56360.
Parameters accessible by the two levels are shown
above.
At the flashing cursor on the first digit of the Login code
number, press either or membrane switches to
reach the required digit.
To set this digit and pass to the next digit, depress the
switch. Continue until all digits have been set, and
depress the switch to enter the complete code.
If an incorrect value is entered, access to subsequent
programming pages is prevented and the display reverts
to the Operating Page.
Quick Reference Guide
Kent -Taylor
MagMaster
ASEA BROWN BOVERI
MagMaster
TM
Electromagnetic
Flowmeters
Keypad Version
A – Advancing to Next Page
Parameter 1
Parameter 2
Parameter 3
Parameter 4
Page 1
Parameter 1
Page 2
Advance to
next page
or
B – Moving Between Parameters
Parameter 1
Parameter 2
Parameter 3
Parameter 4
Advance to
next parameter
Parameter 5
Parameter 6
Parameter 2
Membrane
Switches
Resets totaliser, if parameter
'Tot Clr En' is enabled
Upper
Display
Lower
Display
MagMasterKent-Taylor
32.8
Ltr/s
>42315
SECURITY ACCESS
IM/MM-QRG Iss 1 5/96
CONTROLS AND DISPLAY
Depressing this switch for 5 seconds and then releasing
it will exit the menu system and return to normal operating
mode.
ASEA BROWN BOVERI
ABB Kent-Taylor
Oldends Lane, Stonehouse, Gloucestershire, England GL10 3TA
Telephone: 01453 826661, Facsimile: 01453 826358