—
Access to the monitoring data of UMC100.3 acc. to the UMC100.3 manual section
A1 parameters and data structures on a Fieldbus
Register Bit 7
Bit 15
Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit1 Bit 0
Bit 8
Summary
Warning
Summary
Local Control Reverse
Lockout
warning
Run
Reverse /
Closing
Run
—
Access to the command data of UMC100.3 acc. to the UMC100.3 manual section
A1 parameters and data structures on a Fieldbus
Register Bit 7
Bit 15
Bit 23
Bit 31
Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit1 Bit 0
Bit 8
Bit 16
Bit 24
Auto Mode Prepare
Emergency
Start
Run
Run
Reverse /
Closing
Run
—
Word oriented access to diagnosis data of UMC100.3 acc. to the UMC100.3 manual section
A1 Parameters and Data Structures on a Fieldbus
Register Bit 7
Bit 15
Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit1 Bit 0
Bit 8
Checkback
missing
PTC wiring
failure
PTC hot
thermal
model
Locked rotor
during
(stall)
Phase
imbalance
Phase
loss
Thermal
overload trip
Actuator
problem
UMC
Earth fault
Earth fault
trip (internal
triggered)
I
above high
current
warning
threshold
I
above high
current trip
threshold
I
below low
current
warning
threshold
I
below low
current trip
threshold
Trip/Warning
from
function
block
Trip/Warning
from
function
Trip/Warning
from
function
Trip/Warning
from
function
Trip/Warning
from
function
HW fault on
Custom
application
error
missing
Trip triggered
from
Multifunction
Trip triggered
from
Multifunction
Trip triggered
from
Multifunction
Trip / Warning
function
THD Warning
spec
power
Underload
power
Cooling Time
Running
Just one start
left
Num Starts
diagnosis is
available.
Parameter
out of range
The function of some bits can differ in case the control functions Actuator 1...4, Overload Relay or Transparent are configured.Please refer to the UMC100.3 manual in this case.
14 UNIVERSAL MOTOR CONTROLLER UMC100.3 | MRP31.0 MODBUS TCP COMMUNICATION MODULE MANUAL
To Next Page
Loading...
