ABB PowerValue 11T G2 Series User Manual

14
POWERVALUE 11T G2 1-3 KVA B/S
3.3.2 Test function
Test function means checking the UPS system’s
battery performance by pressing the On-Switch for
more than 1 second while the UPS is operating in
Line mode. The UPS will detect whether the battery
is connected, or if the battery is weak. The UPS can
implement this test automatically and periodically.
The battery test period is configurable.
NOTE
BY DEFAULT, THE OUTPUT IS DISABLED
WHEN THE UPS IS IN BYPASS MODE; THIS
CAN BE MANAGED IN THE USER SETTINGS

3.5.2 In Battery Mode
Press the OFF button continuously for more than
1 second to turn off the UPS. The UPS will enter no
output or standby mode. After 10 seconds, the UPS
will be shut down completely.
3.3.1 Battery recharge
Fully charge the UPS system’s external batteries
by leaving the UPS system connected to the
mains power for approximately 1-2 hours.
The UPS system can operate directly without
recharging, but the backup time may be shorter
than the nominal value specified.
3.4.1 With mains power connecting
Press and hold the ON button for more than 1
second to turn on the UPS. The UPS will be in Line
mode; and the LCD screen will indicate the state
of the UPS.
3.4.2 Without mains power connecting
Even though mains power is not connected to the
UPS, the UPS still can be turned on by just simply
pressing the ON button continuously for more than
1 second when the external batteries connected.
The UPS will turn on in Battery mode, and the LCD
screen will indicate the state of the UPS.
3.5.1 In Line Mode
Press the OFF button continuously for more than
1 second to turn off the UPS. The UPS will enter no
output or bypass mode. In some circumstances,
the UPS might have output power if bypass mode
is enabled. Disconnect the mains power to turn
off the output.
—
3.3 Battery
—
3.4 Turn on the UPS
—
3.5 Turn off the UPS

ABB PowerValue 11T G2 Series Specifications

General

Brand	ABB
Model	PowerValue 11T G2 Series
Category	UPS
Language	English