Figure 1. Hazardous Voltage Nameplate
1.0 SAFETY NOTICES
Install the R-MAG circuit breaker within the design limitations as described on its nameplate and
in these instructions.
Follow your company’s safety procedures.
This breaker should not be used by itself as the sole means of isolating a high voltage circuit. For
the safety of personnel performing maintenance operations on the breaker or connecting equip-
ment, all components should be electrically disconnected by means of a visible break and should
be securely grounded.
This product is intended to be operated and maintained by qualified persons, thoroughly trained
and knowledgeable of the hazards involved. This publication is written only for such qualified per-
sons and is not intended to be a substitute for adequate training and experience in the safety
procedures for this device.
W
ARNING
Detailed descriptions of standard repair procedures, safety principles and service operations are
not included. It is important to note this document contains some warnings and cautions against
some specific service methods that could cause personal injury to service personnel, damage
equipment, or render it unsafe. These warnings do not cover all conceivable ways in which serv-
ice, whether or not recommended by ABB, might be performed or the possible hazardous conse-
quences of each conceivable way, nor could ABB investigate all such ways. Anyone using serv-
ice procedures or tools, whether or not recommended by ABB, must satisfy himself thoroughly
that neither personal safety nor equipment safety will be jeopardized by the service method or
tools selected.
All information contained in this manual is based on the latest product information available at
the time of printing. The right is reserved to make changes at any time without notice.
3
To Next Page
Loading...
Need help?
General
