37
ā
Table 14. Double-pole power output relays with TCS function
ā
Table 15. Single-pole power output relays
ā
Table 16. High-speed output HSO with BIO0007
Description Value
Rated voltage īØī«ī¦īīīīµī·īØīøī·
Continuous contact carry ī®īīµ
īīīīīīīīīīīī ī ī§īīīī īī©īī¦īī” ī§ī«īīµ
īīīīīīīīīīīī ī ī§īīīī īī¦īī«īī” ī©ī¦īīµ
ī¶ī īīīīīīīīīīīīīī¢ī§īī„īīīīī¢īīīīīīī¢ī īīī£īīī īī£īī¢īī¢īīīīīīīī”ī¢īīī¢īīīØīīīŖī¦īīī”īīīī¢
īŖī®īØī§ī§ī¦īØīØīØī¦īīīīøī·īī¦ī¢ī„īīīīīī¢īīī¢ī”īīīīīīīī¢īīīīīīī”īī īīī”ī§ ī«īīµīØī©īīµīØī§īīµ
Minimum contact load ī§ī¦ī¦īīīµīīī¢īīØīŖīīīīµī·īØīøī·
Trip-circuit supervision (TCS):
⢠Control voltage range
⢠Current drain through the supervision circuit
⢠Minimum voltage over the TCS contact
īØī¦īīīīØī«ī¦īīīīµī·īØīøī·
īī§īī«īīīµ
īØī¦īīīīµī·īØīøī·īī¦ī§ī«īīīīØī¦īīī§
Description Value
Rated voltage īØī«ī¦īīīīµī·īØīøī·
Continuous contact carry ī®īīµ
īīīīīīīīīīīī ī ī§īīīī īī©īī¦īī” ī§ī«īīµ
īīīīīīīīīīīī ī ī§īīīī īī¦īī«īī” ī©ī¦īīµ
ī¶ī īīīīīīīīīīīīīī¢ī§īī„īīīīī¢īīīīīīī¢ī īīī£īīī īī£īī¢īī¢īīīīīīīī”ī¢īīī¢īīīØīīīŖī¦īīī”īīīī¢
īŖī®īØī§ī§ī¦īØīØīØī¦īīīīøī· ī«īīµīØī©īīµīØī§īīµ
Minimum contact load ī§ī¦ī¦īīīµīīī¢īīØīŖīīīīµī·īØīøī·
Description Value
Rated voltage īØī«ī¦īīīīµī·īØīøī·
Continuous contact carry ī¬īīµ
īīīīīīīīīīīī ī ī§īīīī īī©īī¦īī” ī§ī«īīµ
īīīīīīīīīīīī ī ī§īīīī īī¦īī«īī” ī©ī¦īīµ
ī¶ī īīīīīīīīīīīīīī¢ī§īī„īīīīī¢īīīīīīī¢ī īīī£īīī īī£īī¢īī¢īīīīīīīī”ī¢īīī¢īīīØīīīīŖī¦īīī”īīīī¢
īŖī®īØī§ī§ī¦īØīØīØī¦īīīīøī· ī«īīµīØī©īīµīØī§īīµ
Operate time īī§īīī”
Reset īīØī¦īīī”īīī īī”īī”ī¢īī¤īīīīīī
ā
Table 17. Front port Ethernet interfaces
ā
Table 18. Station communication link, fiber optic
Ethernet interface Protocol Cable Data transfer rate
Front īī·īīØī½īīīī īī¢īīīī
īī¢īīīīī īīī¹ī¢īīī īīī¢īī·īµīīī«īīīīīīīī„īī¢īī
īī¾ī£īŖī«īīīīīīīī¢īī  ī§ī¦īīī¶īī¢ī”īØī”
Connector Fiber type
1)
Wave length
Typical max.
length
2)
Permitted path attenuation
3)
LC
īīīī¬īØīī«īØī§īØī«īīī īī«ī¦īØī§īØī«īī
glass fiber core ī§ī©ī¦ī¦īīī īØīīī īī®īīī¶
ST
īīīī¬īØīī«īØī§īØī«īīī īī«ī¦īØī§īØī«īī
glass fiber core ī®īØī¦īīīīÆī¦ī¦īīī ī§īīī īī§ī§īīī¶
1) (MM) multi-mode fiber, (SM) single-mode fiber
2) Maximum length depends on the cable attenuation and quality, the amount of splices and connectors in the path.
3) Maximum allowed attenuation caused by connectors and cable together