ABB REG670 - Current Sequence Component CMSQI; Voltage Sequence Component VMSQI; View Metering Values; Function for Energy Calculation and Demand Handling ETPMMTR

Phase to earth voltages and phase angles are displayed here.
6.5.4 Current sequence component CMSQI
Main menu/Measurements/Monitoring/CurrentSequenceComponents(MSQI)/
CSQ
The current sequence component under monitoring displays the positive (I1),
negative (I2) and zero sequence (I0) current values for a three phase line, both
magnitude and phase angle for each component are displayed. These indicate how
well balanced a system is. In an ideal balanced system the zero sequence current
should be zero, the positive sequence current should be equal to the current of each
phase with the same phase angle (relative to GPS) as the L1 phase signal and the
negative sequence current should be zero.
6.5.5 Voltage sequence component VMSQI
Main menu/Measurements/Monitoring/VoltageSequenceComponents(MSQI)/
VSQ
The Voltage sequence component displays the positive (U1), negative (U2) and
zero (U0) sequence components in the system, and includes the magnitude and
phase angle of each component.
6.6 View metering values
6.6.1 Pulse counter logic PCGGIO
Main menu/Measurements/Metering/PulseCounter(PCGGIO)/PC
The output data generated from the pulse counter function include data about the
status of the counter and counter values.
6.6.2 Function for energy calculation and demand handling
ETPMMTR
Main menu/Measurements/Metering/ThreePhEnergMeas(MMTR)/ETP
The output data generated from the energy measuring function includes active
forward/reverse energy and reactive forward/reverse energy.
Section 6 1MRK 502 014-UEN C
Read measured values
30
Operator's manual