ABB REG670 - 9.2 General settings

Here the parameters FineSyncSource, CourseSyncSrc and SyncMaster are
switched on or off.
9.1.2.3 TimeSynchBIN
Main menu/Settings/Time/Synchronization/TimeSynchBIN
Binary input synchronization settings available here are the position of the of the
module, the number of the binary input and the detection mode.
9.1.2.4 TimeSynchDSTBegin
Main menu/Settings/Time/Synchronization/TimeSynchDSTBegin
The starting point for Daylight Savings Time is set here.
9.1.2.5 TimeSynchDSTEnd
Main menu/Setttings/Time/Synchronization/TimeSynchDSTEnd
The end point of Daylight Savings Time is set here.
9.1.2.6 TimeSynchIRIG-B
Main menu/Settings/Time/Synchronization
The type of input, time domain, type of encoding and time zone for IRIG-B are set
here.
9.1.2.7 TimeSynchSNTP
Main menu/Settings/Time/Synchronization/TimeSynchSNTP
Here the IP addresses for the Simple Network Time Protocol servers are set.
9.1.2.8 TimeZone
Main menu/Settings/Time/Synchronization/TimeSynch
The time zone according to Coordinated Universal Time (UTC) is set here.
9.2 General settings
Setting group 1 must be selected before making any changes to the
parameters in General settings menu.
Section 9 1MRK 502 014-UEN C
Read and change settings
36
Operator's manual